Step-by-step D.I.Y instructions for making your own Tripod snake.
The Problem :
A very expensive tripod with delicate joints can be severely damaged if you use it on a black sandy beach with big wave swells on a regular basis.
getting close to the waves on the beach at Jökulsarlon. My previous Gitzo tripod was great in the sea, but I wanted more stability and a tripod without a center column, so that I could get down low if needed. After a week on the beach with my new gitzo, the amount of sand and sea water getting into the joints was shocking and that grinding sound was not very inviting on such a high quality tool. It is a heavy tripod, so useful for beach photography.
How can you protect your expensive Gitzo tripod from sand and sea water, in sometimes extreme conditions?
Most of my shots only work because I get in among the action. I want to be where the interaction of Ocean and beach are exciting. This means having a tripod system that you are confident to get wet.
Don’t forget to share!!
This idea was inspired by watching a snake swallow an egg and also my love of bicycle inner-tubes (and other rubber objects). The concept is very simple and cheap to make at home, but if anyone wants to take this to market, good luck (drop me a line I might post a link to your product).
What you need
I was hunting around in my kitchen cupboard, and I found a Supplement container. I cut the top and bottom off the Supplement container to create a tube, then stretch the rubber tube over the plastic tube. Make 3 of them, but test each one for length until you are satisfied. Stretching the rubber over the plastic tube can be tricky. The final stage should look something like this.
The length of the rubber tube only needs to be as long as your needs dictate. If you shoot low to the ground, you will only need a short tube. If you often have your tripod at full height, you might want to build a smaller version to protect just the bottom sections. In any case, you will need a couple of inches over the shortest use (needs revision).
Extra tripod protection
Thanks for Reading!!
This serves as a very nice grip, especially delicious in cold weather.
Keep your tripod protected while you’re in the Ocean!
It is as easy as slipping the plastic tube over your tripod joint. This is the moment of truth when you find out if you got the sizes correct. When the tripod leg is touching the ground, the extra rubber should fold creating a semi-seal. It is important to note that this doesn’t give your tripod 100% protect, but it does give it a lot of protection. You may need to continue washing your tripod legs occasionally.