Basic Adjustments – Levels
When you adjust levels in post-processing, you are adjusting the range of the brightness/ darkness levels in an image. This is determined through a histogram. The histogram displays the distribution of the different light value in an image. For example, a dark image would have a lot of value at the dark end of the spectrum (left hand side of the histogram), a bright image would have a lot of values at the bright end (right hand side).
To start adjusting the levels, open an image in photoshop and go to image – adjust – levels
The purpose of adjusting the levels is to have the whites in an image just touching the right hand side and the blacks in an image just touching the left hand side so that the distribution of brightness levels goes right across the range.
The right slider will adjust the bright values, the left slider will adjust the dark values and the middle slider will adjust the contrast.
For this example, I have put the right slider just at the edge of the brightest values (205), the left slider is at the edge of the darkest values (13) and the middle slider I have kept at 1,00 (middle). This means that the brightness values in my image are spread over the entire brightness/ darkness range.
The left side of the image has no levels adjustment. It is flat and lifeless as the brightness levels are spread too far. The right side of the image has optimum levels adjustment and is much punchier and has better colours. This is because the range of brightness values in the image are tighter.
Check out one of my Photography Tours
We had driven to Jökulsarlon very early and could see that a good sunrise was developing, but there was very little ice on the beach.
This is a favourite place of mine to sit and wait. This was on a photo tour around Iceland last week to Dettifoss.
The weather was cloudy but as we turned the corner, a gap in the clouds allowed some beautiful, Winter light onto the scene.